+ Reply to Thread
Results 1 to 3 of 3

Thread: replacing fish finder

  1. #1
    Join Date
    Jan 2019
    Posts
    2

    Default replacing fish finder

    I just purchased 2011 18'JVX. Hummingbird fish finder does not work so replacing unit and transducer. I see wire to transducer going under center console and exit at well in front of motor. Is there a tunnel moulded under the deck for this wiring? I also see plastic tubing for all other electrical from console to motor. Any best way to install new transducer cable?
    Am thinking using wire like electricians use to route wiring to boxes.
    Thanks for any help.
    Speranza

  2. #2
    Join Date
    Feb 2008
    Location
    Southern WV & NC OBX
    Posts
    13,629

    Default

    Remove the old d'ucer , cut the puck off ...
    Now you can use the old wire to pull the new threw from the stern
    WV 08 DLV198 HONDA 115
    OBX 99 C-HAWK 13 YAMAHA 150

  3. #3
    Join Date
    Jul 2018
    Location
    South Jersey
    Posts
    38

    Default

    Or, if you want to save the wire, Attach masonry twine to the FF end of the wire, tape up that connection real good with electrical tape, and pull it out through the stern. The tie it to the new wire and repeat.

    It's a good idea to tie another piece onto the wire, and pull that forward, too. Then you'll have a pull string in place for the next project.

    Last edited by Toolguy73; 07-15-2019 at 12:30 PM.
    2015 178 DLV, 90 ETEC

+ Reply to Thread

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

     

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts